Turning And Milling The Surface Of Commutator Pump Compressor Rotor WIND-WGK-2X
(1) Application:
The turning machine WIND-WGK-2X can turn commutator face and rotor OD,
(Turn commutator face and rotor OD is with different cutter and belt)
The turning machine is a simple rotor turning machine for turning rotor of pump,compressor induction
motor sand, commutator surface of power tool,vacuum cleaner universal motor and so on
(2) Competitive Advantages:
1. With two servo axis,
X axis control the length of turning left right horizontal position
Z Axis control the depth of lathing in vertical position
2. Can turn the Commutator OD surface and Aluminum diecasting Rotor OD
3. Economic Type, easy opeartion for developing countries' user including India
(3) Specification:
Belt press time: 0.1s
Cutting time: programmable
Cutting speed: pneumatic adjustable
Speed frequency: 0-60Hz
Air pressure: 0.5-0.7Mpa
Armature shaft diameter: 3-16mm
Shaft length: 50-350mm
Cutter linear speed: 50-1000m/Min
Weight each cutting: 0.02-0.2mm
Surface roughness: 0.25 micron for commutator
Max concentricity: 0.005mm
Max cutting length: 100mm
Weight: about 350kgs
Dimensions: 930 (L)x630(W)x900(H)mm
HS Code:84581100
(4) Below information is needed when you send inquiry:
Armature drawing or rotor drawing
(5) Touble Shooting:
Question:
We are facing problem in commutator turning machine.See the attached video (Run not work)
Solution:
Please re-connect the wire for touch screen and PLC connection:
1. Manually loosen the screw for fixing the wire, and make the wire well connected
2. After that, tighten the screw
Question:
Now the same problem repeated.Loosen the screw & connection two time & tighten but problem is as it
is.Give solution.
Solution:
We conclude it is the wire connection problem,A new connection wire is needed,
We will send 1pc to you by your courier collect no ****
Please click below link to view the video
youtu.be/KFutDdMXvk4
