50MT Straight Drive Starter Armature Flat Wire Stamping Punch Forming Machine WIND-AWF-F
(1) Application
Flat wire forming machine produce conductor for starter armature bare wire without enamel.
(2) Advantages
1. High efficiency, Cycle time Around 25pcs/ minutes
2. Four cutter cut the flat wire
3. Mitsubishi PLC, Weinview touch screen,Airtac cylinder and valve,Schneider Electrical components
4. Flat wire forming machine WIND-AWF-F is comprised of three major parts,
wire feeder,straightening machine and feed forming
5. The feeding length can be setted on screen, mechanical linkage automatical punch forming
6. Fomring angle is adjustable lainkag
(3) Parameter
Power Supply Voltage: AC220V±10% 50Hz
Air source Pressure: 0.5~0.7Mpa
Varnish Removing Length: 0~50mm
Wire Feeding Length: 150~400mm
Rated Capacity: 2KW
(4) Configuration
| Control device | Mitsubishi PLC |
| HMI |
Weinview touch screen
|
| Imported enamel stripping | Korea SPG enamel remover |
| Penumatic unit | Airtac |
| Elecronic unit | Schneider |
Product related:
The 50MT is a straight drive starter for heavy duty and industrial applications.
The 50MT is available in 12, 24, 32, and 64 volt models and can start engines.
with displacement up to 29.5 liters.
Please click below picture to view video
In theory, forming round coil and flat coil are similar, but in reality, the flat wire forming is complicated than
round wire forming. At the flat wire R angle, the enamel could not be removed easily and fully, and our
machine overcome the problem. Most of the domestic starter armature manufacturers mainly use paint
chemical methods (paint remover) to remove enamel,the disadvantage is the length can not be controlled,
low efficiency, also have some damage to the human body. Our equipment Flat wire winding machine for
producing starter coil had solved this problem in the year 2014 and customers from aerospace filed had
purchased this machine and gave good feedback.
